Goldhofer Assembly

2. Perkins STC's objective of this training is to provide knowledge of the following? *This question is required.

• To train all Perkins STC field personnel on how to assemble a Goldhofer 18' wide 4 line platform trailer
• To inform all Perkins STC personnel the difference tools/resources used in the assembly of the trailer
• To make all Perkins STC field personnel feel comfortable while assemling the trailer
• All of the above

3. Select FOUR tools that areused to assemble the Goldhofer Dual Lane Loading (GHDLL) Trailer. *This question is required.

• 46mm wrench
• 55mm wrench
• 1 1/2" socket
• Phillips screw driver
• Golden grease
• Slide Hammer
• Welder

4. What size consoles are needed to make a Goldhofer 18' wide platform trailer? *This question is required.

• 1'
• 2'
• 3'
• 4'

5. You should start the assembly with the modules blocked up. *This question is required.

• True
• False

6. Position side to side arm with bolt heads _____. *This question is required.

• Up
• Down

7. When would be the best time to install the tow bar arm? *This question is required.

• After the 2 halves are assembled together
• After you install the tow bar on the front of the module.
• Before lunch
• Before the 2 halves are assembled together

8. What THREE things should be done with all bolts and pins before installing the consoles? *This question is required.

• Clean
• Throw away
• Inspect
• Put in escort vehicle
• Lube

9. The position of the offset console is the allow the clearance for the side to side steer arm. *This question is required.

• True
• False

10. Insert axle pins ____. *This question is required.

• In first axle of the 4 line module before lifting.
• In second axle of the 4 line module before lifting.
• In first and second axles of the 4 line module before lifting.
• In all four axles of the 4 line module before lifting.

11. When would you tighten all of the console bolts with an impact wrench? *This question is required.

• As soon as you put them in
• After the tow bar is installed
• After all bolts are installed by hand first to ensure bolts are not cross threaded
• After lunch

12. Which statement is NOT TRUE when installing the tow bar? *This question is required.

• Install the tow bar on the back of the module.
• Use a crane and a little help by hand
• Attach with 6 bolts
• Tighten bolts with an impact wrench after they have been all started by hand

13. How many bolts hold the control panel to the front of the module? *This question is required.

• 1
• 2
• 3
• 4

14. The air, electrical, and hydraulic lines _____. *This question is required.

• Are cleaned, inspected, and lubed.
• Are stamped with a number, letter, or color code.
• Are connected properly.
• All of the above

15. The hydraulic cross over lines are connected between the ____ using a 46mm wrench. *This question is required.

• Axles
• Tow bar and the truck
• Modules
• All of the above

16. Pound the side to side steer arm pins with a ______. *This question is required.

• Screw driver
• Allen wrench
• Slide hammer
• Socket and ratchet